MODEL : ATP-U1ATX30L (
300W)
1.
Specification
1.1
AC Input Voltage: 90 to 132 or 180 to 264 Auto selectable 50 to 60 Hz.
1.2
DC Output: 300W maximum
|
|
Output-1 |
Output-2 |
Output-3 |
Output-4 |
Output-5 |
|
Voltage: |
+5V DC |
+12V DC |
-5V DC |
-12V DC |
+3.3V DC |
|
Maximum Load: |
30A |
16A |
0.5A |
0.8A |
15A |
|
Minimum Load: |
3A |
2A |
0.1A |
0.1A |
0.3A |
|
Ripple: |
50mv |
120mv |
50mv |
120mv |
50mv |
|
Ripple/Noise: |
100mv |
150mv |
100mv |
240mv |
50mv |
|
Line Regulation: |
±1? |
±1? |
±1? |
±1? |
±1? |
|
Output Regulation: |
±5? |
±5? |
±10? |
±10? |
±5? |
|
Cross Regulation: |
±5? |
±5? |
±10? |
±10? |
±5? |
Note:
1. Noise Test – Noise bandwidth
is from DC to 20 MHz.
2. Ripple frequencies greater
than 1MHz shall be attenuated by the measurement
System.
3.Add 0.1uF/10uF capacitor at
output connector terminals for ripple and noise
measurements.
4.The combined total power from
5V & 3.3V shall not exceed 180W.
.The combined total power from
+5V and +12V & +3.3V shall not exceed 278W.
5.+5V SB DC Output 2A.
1.3 PS-ON
Remote On/Off Control:
When PS-ON is pulled to TTL Low, the DC output is
to be enabled.
When PS-OFF is pulled to TTL high, the DC output is to
be disabled.
1.4 PW-OK
PW-OK is power good signal and should be asserted high
by the power
supply to indicate that +5VDC and +3.3VDC output are
above the under
voltage thresholds of the power supply TTL. compatible
signal out with
100ms to 500ms.
| 
